Cadmium
Detailed engineering
Issue-ready isometrics and annotated GADs, in minutes.
Isometrics and GA annotation take up more drafting hours than almost anything else on a project. Cadmium takes your 3D model to a finished, annotated isometric, and annotates the GAs you extract so you can issue them.
95%less manual rework per isometric
10 minper sheet, including engineer review
Every revisioncompared automatically, sheet by sheet
Deliverables
What changes on the job.
| Deliverable | Today | With Cadmium |
|---|---|---|
| 3D equipment models | Modelled by hand from vendor GAs | Built from the vendor GA, nozzles included |
| Piping isometrics | Hours of clean-up per sheet | Finished sheet, native DWG and DXF |
| Spool drawings | Drafted one at a time | Generated with weld and cut data |
| GAD annotation | Labels and dimensions moved by hand | Your GA annotated, as DGN and PDF, in seconds |
| Bill of materials | Rebuilt after each change | Generated from the model with every run |
| Revision control | Manual clouding and comparison | Changes detected and clouded automatically |
| P&ID checks | Sampled at review | Every line reconciled before issue |
Solutions used in this phase: Isometrics → GAD annotation →
Pilot
Start with one line, one sheet or one area.
Bring real project data under NDA. We run it with your team, on your templates, so your engineers can judge the output against their own work.
- ScopePick a representative sample with your lead engineer.
- RunWe run it on your template and standards.
- CompareYour team checks the output against the manual result.